Fandom

Scratchpad

Duct tape

216,226pages on
this wiki
Add New Page
Discuss this page1 Share

Ad blocker interference detected!


Wikia is a free-to-use site that makes money from advertising. We have a modified experience for viewers using ad blockers

Wikia is not accessible if you’ve made further modifications. Remove the custom ad blocker rule(s) and the page will load as expected.

duct tape stuff

designs

duct tape wallets(yea some more)

Ws1

step one

Step 1 The first step is to create a large sheet of duct tape 8.5 inches by 7 inches. This is the key to any duct tape project, with a sheet of tape you can make anything! Rip a strip of tape at least 8.5 inches in length and place sticky side up on your working surface. rip a second piece of equal length and place sticky side down half way over the first strip. Fold the rest of the strip facing up over the second strip. Flip over the two strips and place a third strip sticky side down covering the remaining sticky part of the second strip. Flip the sheet again and continue extending the size of the sheet until the needed size is satisfied.

Ws2

step two

Step 2 Trim the edges, fold the wallet in half and tape the sides to create a large pocket to hold bills.

Ws3

step three

Step 3 To create credit/business card pockets create another sheet 4 by 3.5 inches.

Ws4

step four

Step 4 Fold 1.5 inches over. To create two more pockets, repeat the step above and then tape the two pieces together, taping the second pocket a little lower on top of the first piece.

Ws5

step five

Step 5 Tape the edges of the pockets and then tape the whole piece to the large pocket. To create another pocket, leave the inside part untaped.

Ws6

step six

Step 6 Make a sheet of tape (as in the first step) larger than your ID card. Cut the sheet so the outside part of the frame is slightly larger than the height and width of the ID. Cut the inside .5 centimeters, (big enough you can see you picture and info, but small enough the ID can't fall through the opening. Now trim the outside so it is slightly larger in all directions than your ID. Tape three sides of this window to the inside of your wallet, or on top of the credit card holder. It'll take a some trial an error to get it right, but it will be a great addition to the wallet. When your done, the ID should be able to slide into the untaped side of the holder, and once in, not fall through the open window.

Ws7

step seven

Step 7 Tape the completed pocket to the large pocket and again you can create an extra pocket if you wish by leaving the inside part untaped.

Ws8

step eight

Step 8 This is the completed wallet. There are an infinite ways to personalize this design. Some ideas I've embeded in mine are coin pockets within the large bill pocket and placing flaps on the credit card holders so business cards don't fall out when the wallet gets dropped.


help us

add some more for us to use and make this a real wikia

Also on Fandom

Random wikia